Viscosity Controller
parameter | |
Length × Width × Height | 28CM*22CM*106CM |
Precision control range | ±0.2sec. |
voltage | 220v |
power | 10w |
Instructions for Use
Connect the equipment as shown in the diagram above;
After adjusting the ink/paint color, turn on the 220V power supply and the compressed air source;
Press the "Clean" button for 10-15 seconds until solvent from the solvent pump enters the test cup;
Open the ink pump valve, the red display shows the current ink viscosity value (generally between 800-2000). After the red value stabilizes, adjust the green value to match the red value;
When leaving get off work, press the "Clean" button for 3-5 seconds. For long holidays or periods of non-use, circulate solvent for 10-20 seconds for cleaning;